This is topic Time to point an laugh in forum General Talk at Northern California Ford Owners  .


To visit this topic, use this URL:
https://californiafords.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=1;t=057182
Posted by fast305s (Member # 11897) on :
 
A friend of mine put in some longtubes in his 93 notch, while doing so he managed to smash the portion of the wiring harness riding on top of the tranny when he lifted the motor. Long story short the wires didn't like it much an lit up for a second. Nothin serious but it did damage the harness a bit. My question is what harness would he need to get to replace it( I'm pretty sure its the portion of the harness holding the clutch position sensor an what not) an what would be the easiest way to get the old one out an the new one in? Any help would be much appreciated [patriot]

[ November 25, 2012, 07:28 PM: Message edited by: fast305s ]
 
Posted by REDLIGHTING (Member # 11296) on :
 
I think It's the reverse lights and clutch switch
 
Posted by fast305s (Member # 11897) on :
 
I'm assuming its a bitch to get all that out?9
 
Posted by REDLIGHTING (Member # 11296) on :
 
I think it comes in under the driver seat and then to clutch pedal, the reverse wiring not sure just follow it. You can always replace the damage section.
 
Posted by 89Rodknocker (Member # 2951) on :
 
If it is the nuetral safety switch that goes to the trans i have a harness id sell yall. pm if intrested.
 
Posted by Nifty50 (Member # 9987) on :
 
check the muffler bolts [Razz]
 




Fueled by Ford Mustang Owners
on CaliforniaFords.com