This is topic droping in a 01 4.6 on my 98 need help !! in forum Tech Talk at Northern California Ford Owners .
To visit this topic, use this URL:
https://californiafords.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=6;t=029557
Posted by 86 T TOPS (Member # 8855) on
:
Hey folks I'm pulling out the engine out of my 98 and droping in one from a 01 crown Vic but I see that I have to swap all the pullies and it also looks like the top and lower intake manifold they all look diffrent . Anyone here has done this ? I need help ASAP folks
Posted by 70stang351w (Member # 9948) on
:
Try this site
http://www.crownvic.net/
Posted by SacStangDriver (Member # 8304) on
:
is your car an existing 4.6?
Posted by 86 T TOPS (Member # 8855) on
:
Yes its a 98 gt
Posted by SSP NOTCH (Member # 13449) on
:
The vic motor is a little different than the mustang motor, but the differences are easy to swap. The throttle body and plenum point the opposite direction on the vic motor. Just unbolt your mustang one and bolt it onto the vic intake pointing the correct direction for you mustang. Then the only other thing that you should have to change is your exhaust manifolds, because the egr pipe on the mustang plenum goes to the passenger side manifold and the vic one goes to the drivers side. Everything else should match up without issue. Hope this helps.
Posted by 86 T TOPS (Member # 8855) on
:
Ssp notch how about the pullies ?they all look diffrent do I need to swap em aswell
Posted by SSP NOTCH (Member # 13449) on
:
Ive never heard of people having to swap the pulleys. But i dont see why the ones from your mustang wouldn't just swap over. Id leave the vic pulleys on and see if they work. If they don't, swap over your mustang stuff.
Posted by dean-93 (Member # 9401) on
:
I have a 99 gt pi dorman intake,throttle body and elbow ,and timing cover take it all for 40$$$$
http://sfbay.craigslist.org/nby/pts/5123743617.html
Fueled by Ford Mustang Owners
on CaliforniaFords.com