This is topic Another Noob Question in forum Tech Talk at Northern California Ford Owners  .


To visit this topic, use this URL:
https://californiafords.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=6;t=025580

---

Posted by fredfifty (Member # 10320) on :
 
there are 2 bolts that attach the PS pump. one is a nut that fastens down and the other is a bolt that threads into the block..the bolt that threads into the block, does it sit flush against the bracket or is there a small gap (which i have)...ive tightened it down but it wont go anymore, leaving a small gap...

thanks
 

---

Posted by 4iHatch (Member # 11298) on :
 
throw a washer in there. bolt might be too long if its not the original one. just put a washer in and problem solved
 

---

Posted by fredfifty (Member # 10320) on :
 
its a factory bolt though..? if anybody can check theirs and let me know, thanks...
 

---

Posted by sydewayzLX50 (Member # 10217) on :
 
+1 add a washer
 

---

Posted by ALMOST STOCK (Member # 10085) on :
 
Just went out and checked my 89 and there shouldn't be a gap; it pulls up tight to the accessory bracket.

[ November 09, 2011, 11:56 AM: Message edited by: ALMOST STOCK ]
 

---

Posted by Nifty50 (Member # 9987) on :
 
Yea , if you're not using the accessorie bracket then there would be a gap
 

---

Posted by fredfifty (Member # 10320) on :
 
wierd. i have the acc bracket on, but ill just add washers, thanks!
 

---

Fueled by Ford Mustang Owners
on CaliforniaFords.com