This is topic 4.6 2v motor swap. in forum Tech Talk at Northern California Ford Owners .
To visit this topic, use this URL:
https://californiafords.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=6;t=017889
Posted by warhorse58gt (Member # 7702) on
:
thinking of swaping a buddy's motor out. and wanted to get a idea of how long it will take.
2001 stock 4.6 5spd. putting another stock 4.6 in. done lots of 5.0 fox swaps. but i haven't done a 4.6 before.
Posted by Blind (Member # 3052) on
:
it's not too bad, but make sure you pull the hood off and you get the car up really high, I put my DOHC motor in with the tranny (minus shifter) and the exhaust manifolds bolted up, and the SOHC was a whole lot easier to get out.
it takes no longer than a 5.0 for me, and I've only done it once.
[ April 22, 2008, 11:12 PM: Message edited by: Blind ]
Posted by warhorse58gt (Member # 7702) on
:
drop it threw the bottom?... like a ls1 firebird?
Posted by Blind (Member # 3052) on
:
I did it from the top...like a mustang
Posted by warhorse58gt (Member # 7702) on
:
quote:
Originally posted by Blind:
I did it from the top...like a mustang
sweet i was worried when you said get it real high..
Posted by Blind (Member # 3052) on
:
I used a set of 6 ton / truck jackstands at near their max so I could swing the tranny almost straight down with my load leveler then lift it back up to drop the motor mounts in place on the k-member.
Posted by warhorse58gt (Member # 7702) on
:
sounds for the most part just a straight up swap.. cool man thanks for the info..
Posted by FoX GT (Member # 4587) on
:
I drop the tranny first. Don't have to get the car so high, no load leveler, etc. Takes about 8ish hours.
Fueled by Ford Mustang Owners
on CaliforniaFords.com