This is topic Custom Headers in forum Tech Talk at Northern California Ford Owners  .


To visit this topic, use this URL:
https://californiafords.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=6;t=016864

---

Posted by 289fia_cobra (Member # 3813) on :
 
I have a unique situation. I have a Cobra with headers that go straight down towards the side and ends with a flange where all 4 pipes are tightly welded together.

Hooker made these but they're off by about that 1/8-1/4" too far "up" from horizontal. Here's a pic of how it sits currently:



As you can see, its too close in the vertical orientation. Ideally, I need a full 1/4" gap up top.

So I need a shop that can make a slight bend downwards about 4" from the flange.

Any recommendation? ( Santa Clara area ideally.)

[ September 27, 2007, 12:19 AM: Message edited by: 289fia_cobra ]
 

---

Fueled by Ford Mustang Owners
on CaliforniaFords.com