This is topic machine work? in forum Tech Talk at Northern California Ford Owners .
To visit this topic, use this URL:
https://californiafords.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=6;t=015044
Posted by svfreerider87 (Member # 5748) on
:
anyone have an educated guess as to how much i'm gonna end up spending to have my heads redone and mildly ported (gt-40 aluminums) and my block machined? (for 331 stroker)
[ November 08, 2006, 01:41 PM: Message edited by: svfreerider87 ]
Posted by r3dn3ck (Member # 3192) on
:
yeah... bout 800 bucks normally. Usually a bit more if there's a full valve job in it too.
Posted by 93mustang50 (Member # 6642) on
:
$800 Hundred is a smokin deal(have fun finding that deal). I would say between $2000 and $3000 for shortblock and heads.
Posted by 93mustang50 (Member # 6642) on
:
sorry guys, didnt read close enough(little drunk, yes it noon)heads and machined block $800 sounds about right.
Posted by svfreerider87 (Member # 5748) on
:
I found shop that'll take care of the block (stroke it to 331 magnaflux etc...) and check and reset my heads plus mildly port them for 800$ sounds like a good deal yes?
Posted by Maxoctane (Member # 1466) on
:
Try Rob's auto machine in Hayward. Great prices and they know 5 liters very well. They've built 3 motors for me so far.
Posted by DLo (Member # 6133) on
:
Goto Jeff's, fool.
Posted by svfreerider87 (Member # 5748) on
:
I am going to jeff's i'm dropping my heads off tomorrow possibly the whole engine depends how i'm feelin.
Fueled by Ford Mustang Owners
on CaliforniaFords.com