This is topic Replaced intake, trouble keeping it running in forum Tech Talk at Northern California Ford Owners .
To visit this topic, use this URL:
https://californiafords.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=6;t=013469
Posted by 90cobraclone (Member # 6354) on
:
WELL I WAS RUNNING A COBRA INTAKE THEN SWITCHED TO A TRICK FLOW BUT I HAD TO RUN THE STOCK EGR FOR A WEEK SO LAST NIGHT I PUT ON THE EGR PLATE NEW GASKETS AND IT WILL RUN IF I KEEP IT GOING AND MAYBE IDLE 15 SEC THEN DIE DONT HEAR ANY VACCUM LEAHS NO CHECK ENG LIGHT
[ March 04, 2006, 12:48 PM: Message edited by: BlackNGold ]
Posted by BlackNGold (Member # 655) on
:
.......Did you figure it out?....Obviously, check all your connections again and then check what your TPS voltage is set to and that all your sensors are plugged back in...
BTW~please don't type in caps, it means you're yelling...
Good luck
Posted by 90cobraclone (Member # 6354) on
:
all sensor hooked up
Posted by putter (Member # 4253) on
:
Did you replace your "ported gasket and ported egr spacer"?
Fueled by Ford Mustang Owners
on CaliforniaFords.com