This is topic Pro-charger on a 5.0 stock bottom end? in forum Tech Talk at Northern California Ford Owners  .


To visit this topic, use this URL:
https://californiafords.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=6;t=013329
Posted by icall_666_yellow94GT (Member # 6417) on :
 
Putting a Pro-charger on a stock bottom end, 120k,155 PSI 1-8 of a 94 mustang 5.0? 9 PSI safe or no. [Confused] feed back plz.
 
Posted by Luke87GT (Member # 21) on :
 
the devil is in the tune.

If compression and leak-down are good, I wouldn't hesitate...
 
Posted by slowback67 (Member # 6348) on :
 
if you don't beat on it too bad you should be cool. i'd start a fund for a short block if or when it starts to give your ready to roll.just my 2cents. [patriot]
 
Posted by mustanggt5091 (Member # 444) on :
 
if the motor is in healthy condition, you add the additional hardware needed for your application and get a tune you should be fine.
 
Posted by NO MANRZ (Member # 566) on :
 
Like everyone said, with a solid fuel system and tune, you'll be fine. Should make something in the lower 300rwhp range with exhaust. Most people add aluminum heads, intake and cam before the supercharger for 400+ rwhp.
 
Posted by icall_666_yellow94GT (Member # 6417) on :
 
i was going to go with heads and intake befor pro-charger, is wiondsor R heads any good from world casting?
 




Fueled by Ford Mustang Owners
on CaliforniaFords.com