This is topic Ignition column/lock? in forum Tech Talk at Northern California Ford Owners .
To visit this topic, use this URL:
https://californiafords.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=6;t=011141
Posted by blind (Member # 3052) on
:
How hard are these to replace?
http://secure.50resto.com/product1.cfm?SID=1&Product_ID=1211&Category_ID=762
The black thing in that picture that the key goes in has been busted off on mine forever, the lock function normally but when I get pulled over the cops always ask me if I hotwired the car
I don't see any obvious bolts that would let me remove it, any help?
Posted by 92stangLX (Member # 3252) on
:
According to my service manual to remove:
- Disconnect the battery ground cable and air bag backup power supply
- remove two trim shroud halves by removing retaining screws
- disconnect ignition switch electrical connector
- turn iggnition key lock cylinder to the RUN position
- disengage the ignition switch from the actuator pin.
To install:
- adjust the ignition switch by sliding carrier to the RUN postion.
- Make sure lock cylinder is in Run postion.
- Install ignition swithc onto the actuator pin.
- Install the two retaining screws
- connect elctrical connection to ignition switch
- connect battery ground
- install trim shrouds
- connect air bag battery backup
Posted by Mr JoCo (Member # 1549) on
:
All u gotta do is push the little pin, with the key in the cylinder and it pops out.
Posted by Cstang50 (Member # 4925) on
:
quote:
Originally posted by Mr JoCo:
All u gotta do is push the little pin, with the key in the cylinder and it pops out.
Posted by blind (Member # 3052) on
:
wow, that was way easier than I expected, lol thanks
Fueled by Ford Mustang Owners
on CaliforniaFords.com