This is topic edelbrock heads good for blower?? in forum Tech Talk at Northern California Ford Owners  .


To visit this topic, use this URL:
https://californiafords.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=6;t=009637

---

Posted by SIDEWAYZ50 (Member # 4868) on :
 
i recently put edelbrock performer 5.0 heads (6037)with the e303 cam and rpm2 manifold on my car i was wondering if i could put a blower like a paxton or vortech 6psi..the only thing is that i dont want to end up blowing up my motor or blowing head gaskets every time i push it hard??
 

---

Posted by 88blackstanggt (Member # 4654) on :
 
is it a stock bottom end if so you will probably be fine but make sure to get a good tune before you start pounding on it. but all in all unless something else is freaked up then youll probably be fine.
 

---

Posted by Eddie510 (Member # 2354) on :
 
yea it is a stock bottom end. go get it tunned cousin!
 

---

Posted by SIDEWAYZ50 (Member # 4868) on :
 
Does it matter if they are not the o-ringed heads?
 

---

Posted by Fostang (Member # 3752) on :
 

quote:

---

Originally posted by SIDEWAYZ50:
Does it matter if they are not the o-ringed heads?

---

I'd be more worried about the bottom end than o ringed heads.


I ran 8 pounds on a heads cam intake etc combo with hype pistons and roughly 9.5 compression and about 30 degrees total timing .

You'll by fine just get it tuned.
 

---

Posted by SIDEWAYZ50 (Member # 4868) on :
 
cuddies.....kool..i was leaning more to the 6psi....soo i guess it should be kool...thanx.....any idea where i could get it tuned?
 

---

Posted by Jeff S (Member # 371) on :
 
As long as your fuel sytem is good and it's tuned correctly you will be good to go!
 

---