This is topic ding/burr in my bran new piston in forum Tech Talk at Northern California Ford Owners .
To visit this topic, use this URL:
https://californiafords.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=6;t=009561
Posted by ShiftyGT (Member # 3862) on
:
I just saw this when i was getting ready to instal my pisons in the block!
http://www.californiafords.com/album/00003862/100_0771.JPG
how can i fix this? can i use a small file?
Posted by JohnB (Member # 969) on
:
Personally, I'd use a dremel tool on it. Break out the sanding rolls, and take every edge off that nick. It'll be fine after that. ![[Smile]](smile.gif)
Posted by 2stangs69-91 (Member # 1951) on
:
It is no big deal, use what the first guy said or just use some fine sand paper and sand it flat
Posted by ShiftyGT (Member # 3862) on
:
OK,will do. glad its that easy, i just about had a damn corinary! ill post another pic after i sand it.
Posted by ShiftyGT (Member # 3862) on
:
I know it may be hard to tell from a picture but heres for what its worth. I dont think it is rising up anymore. Would it be safer to go a little deaper with the sanding or a little more even? can i hurt anything by taking a little more off?
http://www.californiafords.com/album/00003862/100_0800.JPG
Posted by ShiftyGT (Member # 3862) on
:
![[Confused]](confused.gif)
Posted by Shok (Member # 3174) on
:
If it was me I would prolly take a bit more off, either way I'd guess you were safe at this point.
Posted by stoauto (Member # 2803) on
:
what the??? should have used some real FINE sand paper and did it by hand.
Fueled by Ford Mustang Owners
on CaliforniaFords.com