This is topic headers for tfs highports in forum Tech Talk at Northern California Ford Owners  .


To visit this topic, use this URL:
https://californiafords.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=6;t=005152
Posted by cobraman_1994 (Member # 467) on :
 
do i have to use custom headers for iron tfs high ports? or can i just use regular ones like jba or bassani [Confused]
 
Posted by cobraman_1994 (Member # 467) on :
 
anyone? [dance]
 
Posted by st5150 (Member # 51) on :
 
Depends on how much you port the exhaust ports. They have holes two sets of header flange styles:

-

It also depends on weather they're long tubes or not. The 1" raised exhaust ports may cause long tubes to hit your floor pan or firewall.
 
Posted by cobraman_1994 (Member # 467) on :
 
im probably going to go get the jba shorties like i had on my 94. i probably wont be touching the heads (excpet to freshen them up) untill i toss on a power adder.
so they should work. if not, ill fab up the headers...again [patriot]
 
Posted by st5150 (Member # 51) on :
 
1 3/4" shorties I hope [Wink]
 
Posted by cobraman_1994 (Member # 467) on :
 
[Big Grin]
with bassani highflow x pipe and dumped 1 chamber flows. my favorite exhaust setup [patriot]
shit, i just might be ready for the car show in september.
it will be ugly, but it should be there [Whoo Whooooo!]

[ August 19, 2003, 11:07 AM: Message edited by: cobraman_1994 ]
 
Posted by 91 5.0 (Member # 1527) on :
 
one of my friends installed his high ports with BBK longtubes. He did say he had to tweek some stuff though.
 




Fueled by Ford Mustang Owners
on CaliforniaFords.com