This is topic Need T-5, Parts List for Installation? in forum Tech Talk at Northern California Ford Owners  .


To visit this topic, use this URL:
https://californiafords.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=6;t=004706
Posted by 88DroptopGT (Member # 2535) on :
 
Sorry if I'm asking a n00b question, but my '88 roller Notch needs a tranny.
On the tranny, what parts do I need to complete the assembly? So far I have this list:

T-5
Tranny Mounts
Double Hump Cross. (It's a V8 though.)
28 oz Flywheel for 302s
T-5 Bellhousing
Clutch Fork
Clutch Cable
Clutch Plate
Drive Shaft to 8.8

It was previously a manual, so I have the pedals. I feel like I'm missing something however, thanks for the advice in advance.
 
Posted by FasterDamnit (Member # 442) on :
 
50 oz. for an '88.

Check out www.fordmuscle.com , the tech section under transmsission.
 
Posted by st5150 (Member # 51) on :
 
There are a bunch of little stuff like the clip that holds the clutch cable to the bell housing, the "dust cover" for the clutch fork, ect
 
Posted by Saint (Member # 2746) on :
 
throw out bearing and piolet bearing. i would get a new rear main seal too
 
Posted by MoostangGT (Member # 2894) on :
 
Do you still have the clutch quadrant, might be a good time to go to an aftermarket since you are putting in a cable anways.
 
Posted by Sean90GT (Member # 33) on :
 
I just got my website back up so you can click on the link in my sig and follow the link at the bottom of the page for the T5 swap parts list. That should about cover it.

Sean.
 
Posted by 88DroptopGT (Member # 2535) on :
 
quote:
Originally posted by Sean90GT:
I just got my website back up so you can click on the link in my sig and follow the link at the bottom of the page for the T5 swap parts list. That should about cover it.

Sean.
Very Helpful. Thanks for the complete list. [patriot]
 




Fueled by Ford Mustang Owners
on CaliforniaFords.com