This is topic AFR 185's, hydraulic roller cams, Funnel Web intake...etc in forum FOR(D) SALE: at Northern California Ford Owners  .


To visit this topic, use this URL:
https://californiafords.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=5;t=120242
Posted by 50DADDY (Member # 3076) on :
 
I've got a set of AFR 185 Renegade 58cc stud mount non-emissions cylinder heads for small block Fords. Upgraded valve springs are good to .650+ lift. Very low miles. Motor is new and car hasnt been driven much at all. These can support some big power and flow 297 cfm on the intake side @ .600 lift. There is a bolt broken in one of the accessory bolt holes on the end of one of the heads. THIS DOES NOT AFFECT ANYTHING!!!! If you have that part facing rearwards it isnt even used. Actually it doesnt really matter at all even if its in the front since there are 2 other bolt holes there also. Or about $60 you can have it pulled if it really bothers you. I will throw in a set of gold aluminum stud mount 1.6 roller rockers with one mismatched brand rocker to make up for that. Besides that they are as good as they were when they came out of the box. Looking to get $1250. No lowballers.

Parker Funnel Web intake for 289/302/331/347. 150$

Procomp Electronics distributor. (MSD copy) with roller compatible gear. $65.00

Also have a custom ground Comp Cams hydraulic roller cam for a blower motor,.555 intake and .576 exhaust lift, with 236 intake and 244 exhaust duration @.050, 114 lobe center.
-$200, obo.

Comp Cams Extreme Energy XE282HR hydraulic roller cam, part #35-522-8, 
- $200, obo.

331 stroker .030 over Icon series race pistons. Part #9921-030. Dyno time only on then. 425 grams each with pin and locks, - $200, obo.

MSN TFI ignition coil, - $40.

I am also looking for a Procharger kit or a Paxton/Vortech setup for a small block Ford.
Email jefflane1970@yahoo.com or call/text 916-996-8316. Jeff.

[ 2014-04-05, 04:32 PM: Message edited by: 50DADDY ]
 
Posted by Fostang (Member # 3752) on :
 
How you doing man nice seeing you around here.
 
Posted by 50DADDY (Member # 3076) on :
 
Doing great man! How've you been? Since i started Horsepower University and working at the track i havent been around here much. Dont do the 5.0 thing anymore but still building Fords though. [Smile]
 
Posted by REDLIGHTING (Member # 11296) on :
 
Does know if that comp cam will fit/work with stock pistons and twisted wedge heads?
 
Posted by 50DADDY (Member # 3076) on :
 
I would say probably not.
 
Posted by v-town coupe (Member # 2771) on :
 
Funnel web real or knock off?
 




Fueled by Ford Mustang Owners
on CaliforniaFords.com