This is topic Gauging Interest - Big HP 331 Stroker Longblock in forum FOR(D) SALE: at Northern California Ford Owners .
To visit this topic, use this URL:
https://californiafords.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=5;t=116428
Posted by CornOil_&_Boost (Member # 5888) on
:
So I might be doing a motor swap here soon so wondering if there is interest in my not so old 331 stroker.
Give some small details.
Built by Dan, Turbo50 back in Aug 2011
a4 block - freshend the main bearings this year because I pulled the motor ..so why not...
331, 9.5:1 Comp
Scat Hbeams and 4340 crank
JE pistons - Hellfire piston rings
Ported AFR heads with After market Springs, 1.7 rockers and rocker stud girdle
Custom Turbo Cam - idles like a b-cam drives like stock
Ported and fully show polished Systemax intake
ARP2000 rod bolts
ARP Main studs, Head Studs...etc..
Cometic Head gaskets..
7qt oil pan tapped already for drain
That's a very low-level breakdown for now.
Motor is capable of holding 1000RW reliably...
If I get a good interest, I will send a full scope breakdown of what's inside.
I'm not going to part the motor at all...
$5000 - but willing to entertain a reasonable, non-crackhead, type offering...no trades obviously since I will be swapping...shortblock alone will cost about that....
add fuel and accessories and it's ready to go.....definitely a turbo motor but will be able to handle any type of boost thrown at it..
so not bad for an 8 sec capable street motor that revs to 6800 and is as solid as they come...
[ 2013-10-30, 06:47 PM: Message edited by: CornOil_&_Boost ]
Fueled by Ford Mustang Owners
on CaliforniaFords.com