This is topic F/S: Custom Bolt in Roll Bar Setup in forum FOR(D) SALE: at Northern California Ford Owners .
To visit this topic, use this URL:
https://californiafords.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=5;t=072531
Posted by Yellow94GT (Member # 431) on
:
This setup was custom built in a 98 GT, but should work in any SN95 style car and possibly in a Fox. This setup connects to the chassis in 8 points, 4 of which are optional/removable. The tubing is mild steel and is coated in silver powder coat, then clear powder coat over that. There are only a few blemishes in the powder coating one is pictured below and the other is on the driver side door bar and was caused by sliding over the bar wearing jeans that had buttons on the pockets, (nothing major).
Make note that the door bars are not the swing out style, but they can be easily removed for daily driver use then installed when you go to the track.
Included is all the hardware and mounting plates as well.
This roll bar setup cost over $2000 to build and I have the receipt for it.
$900 obo!!
Sorry for the dust in this one!
[IMG]http://i68.photobucket.com/albums/i26/dwigg3394/324[IMG]
[ December 12, 2009, 03:14 PM: Message edited by: Yellow94GT ]
Posted by Yellow94GT (Member # 431) on
:
TTT
Posted by 1RaReSnAkE (Member # 7951) on
:
Do u think this would work for a 04 cobra?
Posted by BLK35th (Member # 4685) on
:
man I want this but my wallet is saying not yet.lol. Thats a good deal.
Posted by Yellow94GT (Member # 431) on
:
TTT
Posted by Yellow94GT (Member # 431) on
:
Buyer's flaked.
TTT
Posted by Yellow94GT (Member # 431) on
:
TTT
This is a very high quality piece people! ![[burnout]](graemlins/burnout.gif)
Fueled by Ford Mustang Owners
on CaliforniaFords.com