RRRCobraSC281
¯
Member # 7086
|
posted
 
 
Rear end was on my project 88 Modular Fox, but suspect the pinion bearing is going out. Gears and oil was only installed to get this project as a roller and only has about 14 miles(trip to the Ford dealership and back for initial alignment and brake bleed). Just finished installing my 4.10 rear end and have no use for this one. Great for 5 lug conversion as it was on my 88 Modular Fox. Just recommend replacing the clutch pack and new bearings and seals. The pinion bearing can't be too bad since a visual prior to installing the posi and gears didn't see any issues. Probably wasn't torqued down properly.
$250 obo.
I also have the North Racecar Cobra caliper brackets to maintain Fox width. $140 New never used and have all the bolts and fittings.
[ November 16, 2009, 12:47 AM: Message edited by: RRRCobraSC281 ]
--------------------
Project 93GT500 has started
90 Coyote Coupe (sold)
88 Mach 1 Coupe MM&FF 6/14 (sold)
65 FFR Cobra (sold)
Posts: 1746 | From: Fremont, CA | Registered: Sep 2006
| :
|
Email this post to someone!
Printer friendly view of this Ford topic
