This is topic FS: home ported Eaton and plenum in forum FOR(D) SALE: at Northern California Ford Owners  .


To visit this topic, use this URL:
https://californiafords.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=5;t=068132
Posted by johnson50 (Member # 4608) on :
 
To start off, the blower has 46k on it and pullied(2.76 upper only) since around 34k. Its in great shape and I never had it tuned with the new port job.:shrug: I was kinda hoping I could bolt it up to my friends cobra and see what type of #'s it would pull but he decided to get a whipple. Reason for selling is I just bought a 2.3 whipple and this is just taking up room in garage now. I am sure you will not be disappointed with the power level it should make. All ports have been gasket matched and plenum to blower ports have been port matched as well. I did the majority of the porting myself and my friend came behind me to smooth everything out. Let me tell you that the port surface is as smooth as a babies bottom;-). All I'm asking is $350+shipping for the unit. the only defect it has is on the plenum itself and you can see in the last picture, on two areas the port job went through the indented parts. However, the two area's have been repaired using double aluminum tape along with apoxy on both sides to ensure structural integrity.

-

-

-

-

-

-

-
 
Posted by johnson50 (Member # 4608) on :
 
TTT... [patriot]
 
Posted by alexdel209 (Member # 9239) on :
 
what parts would i need to make this work for my 2001 cobra?if i can find those for a reasonable price i will buy this from you
 
Posted by RED@7kVERT *8850GT* (Member # 5909) on :
 
hey good job on the blower!! [patriot]

theres more power to be had tho!

port the front plate that the rotors are attached to, its allows them to ingest much more air. and plug up the silencer holes, it makes the eaton even louder if that s your thing and it also drops IAT's by ~8*.

-

TTT for ya! this thing should perform!!
 
Posted by johnson50 (Member # 4608) on :
 
quote:
Originally posted by alexdel209:
what parts would i need to make this work for my 2001 cobra?if i can find those for a reasonable price i will buy this from you
You would need the whole intercooler setup(hoses, pump, heat exchanger, and the intercooler itself and thats very hard to find) brackets, possibly injectors etc. It might not be that cheap to convert your car unless you can find someone with a whole swap kit for sale.
 
Posted by johnson50 (Member # 4608) on :
 
blower and plenum going on ebay. Pulley and Hub still available
 




Fueled by Ford Mustang Owners
on CaliforniaFords.com