quote:

---

Originally posted by shade-tree:
might bring out my emissions-legal POS sat. night on the GT-40 setup.

---

So it passed smog??
 

---

Posted by shade-tree (Member # 298) on :
 
heh. didn't try yet. I assume it will. I'll risk the drive on april '02 tags.
 

---

Posted by 99convcobra (Member # 1339) on :
 
do it dude!!!
 

---

Posted by st5150 (Member # 51) on :
 

quote:

---

Originally posted by AaronC:
Camara90 will be there tonight looking to toss up a new best. My POS is down so I won't running, but there to BS and watch Mike. Just seeing who else will be there.

---

Make sure to post his numbers... you can even do it privately if you'd like

Whats new since last time? Just the headers? Is he running the C&L still?
 

---

Posted by AaronC (Member # 86) on :
 
Best run tonight was 11.61 at 119.3 with a 1.74 60' time. Still running on 17" Nitto DR's. Avg run was low 11.7's at 118-119. The air wasn't quite as good as the last time he ran but it was still pretty decent. He borrowed my Pro M. He's gettin one wheel peel so he's gonna have the rear done then hit it up on some ET streets. His 1/8 mile mph was consistently 1 mph higher this time.
 

---

Posted by st5150 (Member # 51) on :
 

quote:

---

Originally posted by AaronC:
Best run tonight was 11.61 at 119.3 with a 1.74 60' time. Still running on 17" Nitto DR's. Avg run was low 11.7's at 118-119. The air wasn't quite as good as the last time he ran but it was still pretty decent. He borrowed my Pro M. He's gettin one wheel peel so he's gonna have the rear done then hit it up on some ET streets. His 1/8 mile mph was consistently 1 mph higher this time.

---

Sweet times! Mike's car is making about 95% of supercharged 5.O's and all but one or so supercharged 4.6's around here look bad with his simple all motor 347 combo!

So why was the C&L replaced? It seemed to be working fine.
 

---

Posted by Camara90 (Member # 134) on :
 
I used aarons meter for most of the runs, at first i ran the c&l and was only hitting high 118. I hope to be upgrading to an 80mm and a 4inch anderson pipe along with the performer rpm swap. Probably gonne have that port matched to some 185's and see what happens. At the moment I need a cage and the torque boxes welded, and some axles, and a locker so i can see what this beast will do on slicks.
 

---

Posted by O.G. Cobra (Member # 747) on :
 
Camara: how much compression? very impressive numbers. how much does your ride weigh? and one last, what tranny?
 

---

Posted by Camara90 (Member # 134) on :
 
car weight with me in it is about 3400, trans is a tremec 3350. Compression is about 10.3- 10.4
 

---