This is topic i need to buy a press but i need to know the diameter of a stock pinion in forum General Talk at Northern California Ford Owners .
To visit this topic, use this URL:
https://californiafords.com/cgi-bin/ultimatebb.cgi?ubb=get_topic;f=1;t=045777
Posted by LUCKY 187 (Member # 4347) on
:
the opening on the press i am looking at is 4 1/4" is a stock mustang pinion bigger then that? someone anyone??
Posted by JohnB (Member # 969) on
:
It's going to be dependent on the gear set. 4.10's are around 3", while 2.73's look like a dinner plate. It only needs to be pressed about 3" to get the bearing off, so a set of blocks and a bearing splitter are all that's needed.
Posted by LUCKY 187 (Member # 4347) on
:
i know any aftermarkets will clear but i guess i am over thinking this. i have done the plates like that before. i seen a press at harbor freight on sale so i was looking to jump on it.
Posted by 166 Merlot (Member # 1549) on
:
Don't be harbor freight guy ![[Whoo Whooooo!]](graemlins/woowoo.gif)
Posted by LUCKY 187 (Member # 4347) on
:
where is a solid ass spot to get a press?
Fueled by Ford Mustang Owners
on CaliforniaFords.com